GnaverBlaster 10/22 Hardware Kit
The official hardware kit for the GnaverBlaster by DB Firearms.
The GnaverBlaster is a monolithic 10/22 pistol that uses Ruger factory 10/22 bolt, recoil rod assembly, and trigger pack. This hardware kit contains pretty much everything else you would need to finish your GnaverBlaster. For the files, please visit the AWCY? Odysee page.
***THIS IS NOT A FIREARM***
This kit is the hardware only. You’ll still need to furnish additional components explained in the build guide to complete your GnaverBlaster.
**this is a DIY kit and due to the nature of DIY firearms no responsibility is taken by DB-Firearms LLC as a result of your build, the legality of it, or the safety of it. Please research your local laws and practice safety when operations your finished firearm.
Kit contains the following parts:
(1) Pre-chambered rifled barrel liner (Redman’s size - .305-.315”) in either 2” or 4”
(2) Receiver trigger cross pins
(1) Nylon bolt buffer pin
(4) self tapping torx screws
(2) 3mm x 10mm steel pins